![]() If using a condenser mic, you may not need to adjust the default value much, but if you have a dynamic mic, you may need a value between 50dB and 60dB, depending on the mic's sensitivity.In the same LEVEL SETUP menu, scroll to, and adjust the HEAD AMP GAIN for MIC 1 until you see that LED activity and it sounds good through the headphone jack. Doing this sets the whole mix to 0.0 dB, or Unity, and from there, you need to set the gain level of the Mic Pre-amp, so that the mic causes the main meter to move between the -20 dBFS and -6 dBFS LED's.Then set the MAIN and USB STREAM knobs to the 2'o'clock dot. Turn up the MIC 1 audio fader 3/4 of the way, to the bold hash mark. Next, you will want to setup your microphone. Press LEVEL SETUP, scroll to, and push ENTER on the VALUE knob to Mute HDMI 1 and HDMI 2. ![]() The PbyP feature requires firmware version 1.20 or later:īefore you begin, you should mute the audio on HDMI input 1 and 2, as your audio sources will be Mic 1 and USB From PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |